P - Select Pulse Dialing
Use this command to configure the modem for pulse dialing. All subsequent
D<dial_string> commands use pulse dialing until either the T command or a tone dial modifier is received by the modem. Tone dialing is the default setting.
This command does not use parameters and generates an ERROR result code when parameters are attached to the command.
Q<value> - Result Code Control
Result codes are informational messages sent from the modem and displayed on the monitor. Basic result codes include OK, CONNECT, RING, NO CARRIER, and ERROR. Use the Q<value> command to enable or disable
result code generation by the modem. If result codes are disabled and an invalid parameter value is entered, the modem does not generate an ERROR result code because result codes are turn off.
Result codes:
_ OK if <value> =
_ ERROR if <value>
T - Select Tone Dialing
Use this command to configure the modem for DTMF tone dialing. All subsequent D<dial string> commands use tone dialing until either the P command or a pulse dial modifier is received by the modem. Tone dialing is the default setting. This command does not use parameters and generates an ERROR result code when parameters are attached to the command.
W<value>—Result Code Option
Use this command to select the modems CONNECT message options.
Result codes:
_ OK if <value> =
_ ERROR if <value>
Command | Function |
|
|
W0 | CONNECT result code reports DTE receive speed. Disables protocol result codes. |
|
|
W1 | CONNECT result code reports DTE receive speed. Enables protocol result codes. |
|
|
W2 | CONNECT result code reports DCE receive speed. Enables protocol result codes (default). |
|
|
Z<value> - Reset and Recall Stored Profile
Use this command to make the modem go
Note: Both Z0 or Z1 restore the same profile
OK if <value> =
_ ERROR if <value>
Command
Z0
Z1
Function
Reset and restore stored profile.
Reset and restore stored profile.
NetComm Roadster Series 56K USB Modem | �m�5�60 �7 |
12 | www.netcomm.com.au |
