Connecting the Power/ Turning on the DVD Player

Before connecting the POWER

The DV-S939 is shipped with the main power (POWER) switch in the on position ( in for the first time, the DV-S939 will automatically enter the standby state and the condition after step 2 below).

ON). When the power cord is plugged STANDBY indicator will light (same

Make sure that all appropriate connections have been completed as described on pages 10 to 13.

Turning on the DVD Player may cause a momentary power surge, which might interfere with other electrical equipment such as computers. To prevent interference, use a wall outlet on a different circuit.

1 For models with a voltage selector, set VOLTAGE SELECTOR to the position of your local power line voltage.

If the preset voltage is not correct for your area, insert a screwdriver into the groove in the switch. Slide the switch all the way to the right (120 V) or to the left (220-230 V), whichever is appropriate.

VOLTAGE SELECTOR

220-230V 120V

2 Plug the supplied power cord into the AC INLET and then into the power outlet on the wall.

AC INLET

Power cord

To a wall outlet

(supplied)

 

Notes

DISPLAY

OPEN/CLOSE

STOP

PLAY

Do not use a power cord other than the one supplied with the DV-S939. The power cord supplied is designed for use with the DV-S939 and should not be used with any other device.

Never have the power cord disconnected from the DV-S939 while the other end is plugged into the wall outlet. Doing so may cause an electric shock. Always connect by plugging into the wall outlet last and and disconnect by unplugging from the wall outlet first.

3 Press POWER to switch on the main power.

The DVD Player enters standby mode.

The STANDBY indicator lights up.

Notes

The buttons on the remote controller do not operate if the POWER switch is set to OFF.

To switch off the main power, pressPOWER again.

4 Press STANDBY/ON on the DVD Player or ON on the remote controller.

The DVD Player turns on and the STANDBY indicator turns off.

The first time you turn on the DVD Player, the Initial Setup screen appears.

Press ENTER, then follow the procedure on page 54 to set up your DVD Player for the first time.

Notes

• To put the DVD Player in the standby mode, press STANDBY/ON on the DVD Player, or STNBY (or ON) on the remote controller. Be sure to set the volume to minimum before putting the DVD Player in the standby mode for the next use to avoid sudden loud sound reproduction.

While the STANDBY indicator lights up, the DVD Player can receive signals from the remote controller. However, if you press POWER on the DVD Player to switch off the main power, the remote controller cannot be used to turn on the DVD Player.

You can change the First Setup later with “Customizing the Function Settings” starting from page 44.

Setting the STANDBY button to standby does not shut off the power completely.

17