Programming the Commands of Other Remote Control Units into the Remote Controller
SEND/LEARN indicator
DVD 
RECVR
SEARCH
Erasing the programmed command from one button
You can only erase memorized commands and not preset ones.
| 1 | Press and hold down the desired |
| MODE button for the command, | |
|
| press the SEARCH button, and |
|
| then release both buttons. |
|
| When you release the buttons, the SEND/LEARN |
|
| indicator lights. |
|
|
|
| 2 | Press and release the button for |
| the command you wish to erase. | |
|
| When you press the button, the SEND/LEARN |
|
| indicator turns off. When you release the button, the |
|
| lamp lights again. |
|
|
|
| 3 | Press and release the same button |
| again. | |
|
| The SEND/LEARN lamp flashes twice. The |
|
| memorized command is erased. |
|
|
|
Note
If no button is pressed for more than 30 seconds during the programming, the SEND/LEARN indicator flashes three times quickly, and the remote controller exits the programming mode. Resume from Step 1.
Erasing all the commands programmed under a MODE button
1 | Press and hold down the desired |
MODE button, press the SEARCH | |
| button twice, and then release both |
| buttons. |
| When you release the buttons, the SEND/LEARN |
| indicator flashes twice slowly and then lights again. |
|
|
2 | Press and release the same MODE |
button again. | |
When you release the button, the SEND/LEARN | |
| indicator flashes twice slowly. This erases all the |
| commands memorized to the MODE button. |
|
|
Notes
•If no button is pressed for more than 30 seconds, the SEND/LEARN indicator flashes three times quickly and the remote controller exits the programming mode. Resume Step 1.
•If you perform an invalid operation during programming, the SEND/ LEARN indicator flashes three times quickly and the remote controller exits the programming mode. Resume from Step 1.
•If many commands have been programmed to the MODE button, then the SEND/LEARN indicator may remain lit for some time during Step 2. This is not a malfunction.
60