Trailer Assembly Instructions (157595 only)
1.) | Remove the top and four sides of the steel crate. |
| |
2.) | Remove |
| |
| fasteners for step 7) |
| |
3.) | Slide |
| |
| (built into the front posts). | Trailer | |
4.) | Install jack onto | ||
| G lock nuts, and washers provided. Tighten to | Frame | |
| 37ft/lbs. |
| |
5.) | Slide caster wheel onto jack and secure with pin. | Jack | |
6.) | Crank jack down until | ||
| |||
7.) | Attach |
| |
| and Class G nuts. Tighten to 180ft/lbs. |
| |
8.) | Check trailer light wire routing though |
| |
| make sure wires are not pinched, stretched, or |
| |
| pass any rough edges. |
|
9.) Crank jack down farther (so a- |
| |
frame goes up) to take weight off |
| |
Rear Shipping Posts | ||
front shipping posts. | ||
10.)Remove front shipping posts. | (one on each corner) | |
11.)Crank jack up as far as it will go |
| |
(so |
| |
weight is applied to wheels) |
| |
12.)Disconnect rear shipping posts |
| |
from frame (remove only the bolts |
| |
at the top of the rear shipping |
| |
posts) |
| |
13.)Roll trailer forward until it is free of |
| |
the rear shipping posts. |
|
Front Shipping
Posts
14.)Attach coupler to
15.)Attach safety cables to the
16.)Attach truck chest to
Truck chest
Coupler
Safety Cables
17