For technical questions and replacement parts, please call
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire instruction sheet to become familiar with this product before you begin using it. This product is designed for certain applications only. Northern Tool + Equipment strongly recommends that this product is not modified and/or used for any application other than that for which it was designed. If you have any questions relative
to a particular application, DO NOT use the product until you have first contacted
Northern Tool + Equipment to determine if it can or should be performed on the product. Before using this product, please read the following instructions carefully.
Technical Specifications
Item | Description | Item | Description |
Square Drive | 1/2" | Air Inlet Diameter | 1/4"- 18NPT |
Free Speed | 145 RPM | Min. Hose Size | 3/8" |
|
|
|
|
Max. Torque | 65 | Max. air pressure | 90 PSI |
|
|
|
|
Air Consumption | 4.5 CFM |
|
|
|
|
|
|
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep this manual and invoice in a safe and dry place for future reference.
WARNINGS AND SAFETY RULES
1.Wear proper clothing. Always use
2.Keep work area clean and well lighted. A dim and/or cluttered work area invites personal injury.
3.Keep children and pets away from work areas. Children can be a distraction and should be supervised by an adult when near the work area. Never allow children to play with this product even if it is turned off.
4.Store idle tools properly. Keep this tool out of the reach of children.
5.Do not use the wrench if under the influence of alcohol or prescription drugs, or if you are tired. Doing so may cause damage to the tool, or personal injury. Do not use this or any tool if you are tired. Use common sense at all times.
6.Always use the proper tools. This tool was designed for a specific task. Do not alter this tool, or use it for a purpose for which it was not intended.
7.Be careful when connecting/disconnecting air supply. It is recommended to use quick disconnects (not included) rather than
8.Use compressed air only. Clean, dry, regulated compressed air at 90 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.
9.Always disconnect air supply when this tool is not being used.
NOTE: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under stood by the operator that common sense and caution are factors that cannot be built into this product but must be supplied by the operator.
1 of 4
