Machine Component Identification
9
nozzles
grommets
gun hooks
flange
nuts
hose hook
handle
Hook Detail
flange nut
Top Hook Detail
Lock Nut
and Washer
t-handle
knob
carriage bolt
III.) Handle Assembly
1.) Attach handle to base with two carriage bolts and t-handle knobs.
2.) Spin a flange nut backwards onto two hose hooks and each gun hook. (see hook detail)
3.) Mount the hose hooks and gun hooks onto the handle as shown.
4.) Make sure the top gun hook points back and the bottom gun hook points forward.
5.) Spin a lock nut onto the last hose hook and push on a washer (see top hook detail). Mount
the top hose hook with another washer and lock nut. Tighten lock nut until it is tight
enough to hold hose hook upright but it can still spin. This allows you to turn hook to
remove the power cord quickly.
6.) Insert grommets into the holes on the handle nameplate.
7.) Press nozzles into grommets according to the colors indicated on the handle decal.