CONNECTIONS
Typical connection with a mixer is illustrated right.
1.Connect the output connection cords from the CD Player to the line inputs of your mixer.
2.Connect the remote control connection cable from the Unit 1 connector on the main unit to the Unit 1 connector on the remote control unit. Repeat for Unit 2.
3.The output connection cords and the remote control connection cables are supplied with the main unit. Be sure to use the supplied remote control connection cables. Use of another cable type might cause damage.
4.Connect Relay or Fader start cables
∙For fader start, attach both side of your CD play to a similarly equipped DJ mixer, as in the top drawing.
∙For relay capability, take the autostart cable and connect the two jacks in the rear of your CD player.
POWER ATTACHMENT: Your CD player is equipped with an IEC style power connector. Please first select the proper voltage for your location. Next, plug in your supplied power cable into the rear of the unit then plug into the appropriate power outlet.
DIGITAL OUTPUTS: This CD player is specially equipped with digital outputs. The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format). In order to use the digital output you must activate the rear panel switch. When the digital output is active the variable pitch slider and pitch bend buttons or pitch wheel will not work.
Note: If digital information was allowed to change in pitch, other devices will not read the digital output properly.
MOUNTING YOUR CD PLAYER
1.Mount the units in your console or rack with 19” EIA rails
2.The transport should be mounted not to exceed an angle of 15 degrees.
3.Your CD player can be affected by excess vibration so mount the units in a secure environment if possible.
| - The Leader in DJ Technology |
|
©1999 Numark Industries | - 7 - | http://www.numark.com |
