Numark Industries DJ-18 DJ18 REAR PANEL DIAGRAM, 7 7 7 8 7, Rear Panel Inputs And Outputs

DJ18

DJ18 REAR PANEL DIAGRAM...

1

4 5 3

REAR PANEL: INPUTS AND OUTPUTS

1.AC Cord. See safety precautions on page 3 for proper treatment of the power cord.

2.GND is the grounding lug for turntables 1 and 2

(phono inputs on Channels 1 and 2). Always use this connection (your turntable cable should have a grounding wire).

3.The Stereo Main Outputs are low-impedance RCA connectors controlled by the Master fader.

4.The Stereo Zone Outputs are low-impedance unbalanced RCA jacks controlled by the Zone Level control.

5.The Tape Outputs are low-impedance unbalanced RCA jacks which output the program mix and allow you to connect any recording device.

6.Mic 2 is a high-impedance 1/4” input.

6 2

7 7 7 8 7 8

7.Channels 1-3 Line Inputs are unbalanced RCA jacks. The Line Input is selected with the toggle switch on the front panel.

You can connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

N O T E : Plug mono audio sources into both Left and Right inputs using a “Y” cable connector.

8.Phono Inputs on Channels 1 and 2 use unbalanced RCA jacks. Your input signal is fed directly to the D J 1 8's high-quality RIAA phono pre-amplifiers so use this position only for moving magnet cartridges. Line level sources will overload the sensitive phono pre-amps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

Numark - The Proven Leader in DJ Technology

©1998 Numark Industries 12 http://www.numark.com