Numark Industries DM2000X Front Panel Diagram, Installation and Operation, Channel Features

DM2000X

DM2000X FRONT PANEL DIAGRAM...

GUIDED TOUR OF FEATURES AND	16
OPERATING INSTRUCTIONS...
	13

If the D M 2 0 0 0 X is your first mixer, please read this entire manual before you begin operation.

If you are an experienced DJ simply replace your old mixer. The D M 2 0 0 0 X can be 10” rack-mounted or used as a free-standing unit. Keep in mind that there are a few features you may never have seen before in a

6

17

5

mixer of this type that you will need to read about.

INSTALLATION AND OPERATION

3

8

4

Study the Connections Diagram on page 13. First, connect all stereo input sources. Next connect your microphone(s) and monitor headphones. Make sure all

114

faders are at "zero" and the unit is off. Finally, connect the stereo outputs to the power amplifier(s) and/or audio sources. Plug the D M 2 0 0 0 X into AC power. Now you are ready to switch it on.

2

12

CHANNEL FEATURES

1.Channels 1, 2, & 3 Rotatable Input Toggle Switches select which source will be live to that channel based on what you have connected to the rear panel input section.

To rotate or replace the toggle a. Turn off all power!

b. Remove corner screws

c. To rotate lift of toggle and place in it’s new position or to replace unplug the old unit and plug in the new one.

d. Screw toggle back into place.

2.The Input Faders are low-noise, low-impedance, high-quality, smooth Alps™ faders. These control individual source levels in the mix.

3.PFL and Channel Cue Assign. The P F L pushbuttons are used to route channel audio to the main volume meter and the Cue Monitor Section.

When a PFL is pressed the main volume meter changes its display to the PFL channel. This allows the DJ to accurately match levels before mixing with that channel’s gain control. The idea is to properly match inputs, not the input with the output!

11

10

79

1514

4.Send Buttons are for allowing a channels pre-fader output to be sent to the send connectors in the rear of the unit. These are used for sampling and other special effects. You would return the send signal through another input channel.

5.Treble, Mid, and Bass Controls are for setting appropriate equalized levels for the music you are playing. When turn all the way left they “CUT” the signal by 30dB for special effects mixing.

6.Gain Controls are for accurately matching audio

levels of the channels.

Numark - The Proven Leader in DJ Technology

©1997 Numark Industries 6 http://www.numark.com