Numark Industries owner manual DM2000X Rear Panel Diagram, Rear Panel Inputs and Outputs

DM2000X

DM2000X REAR PANEL DIAGRAM...

2

8 8 8

1

3 4 5 6 7 6 7 7

REAR PANEL: INPUTS AND OUTPUTS

1.AC Connection. Plug your power cord in here. See safety precautions on page 3 for proper treatment of the power cord.

2.GND is the grounding lug for turntables 1, 2 and 3 (phono inputs on Channels 1, 2 and 3). Always use this connection (your turntable cable should have a grounding wire).

3.The Stereo Main Outputs are low-impedance RCA connectors controlled by the Master fader.

4.The Stereo Booth/Zone Outputs are low- impedance unbalanced RCA jacks controlled by the Zone Level control.

5.Send Output is set by the send buttons pressed on the front panel. Hook up you sampler or other processor here.

6.Channels 2 and 3 Line Inputs are unbalanced RCA jacks. The Line Input is selected with the toggle switch on the front panel.

You can connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

N O T E : Plug mono audio sources into both Left and Right inputs using a “Y” cable connector.

7.Phono Inputs on Channels 1, 2 and 3 use unbalanced RCA jacks. Your input signal is fed directly to the D M 2 0 0 0 X's high-quality RIAA phono pre- amplifiers so use this position only for moving magnet cartridges. Line level sources will overload the sensitive phono pre-amps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

8.Line/Phono Input switch. Use this to allow line level equipment to be plugged into your phono inputs giving you a total of 5 line input options.

Numark - The Proven Leader in DJ Technology

©1997 Numark Industries 8 http://www.numark.com