Rear Panel Features, TOP Panel Features

REAR PANEL FEATURES

1.AC IN – Use the included power adapter to connect the mixer to a power outlet. While the power is switched off, plug the power supply into the mixer first, then plug the power supply into a power outlet.

Note: The mixer is designed to work with the included power supply only. Using an incompatible power supply could result in damage to the unit.

2.POWER SWITCH – Turns the mixer on and off. Turn on the mixer after all input devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off the mixer.

				6		6
				7		7
2	1	3	4	5	4	5
2	1

3.MASTER OUTPUT (RCA) – Use standard RCA cables to connect this output to a speaker or amplifier system. The level of this output is controlled by the MASTER knob on the top panel.

4.LINE INPUTS (RCA) – Connect line-level devices, such as CD players, samplers or audio interfaces, to these inputs.

5.PHONO INPUTS (RCA) – Connect phono-level devices, such as turntables, to these inputs.

6.GROUNDING TERMINAL – If you are using phono-level turntables with a grounding wire, connect the grounding wire to these terminals. If you experience a low “hum” or “buzz”, this could mean that your turntables are not grounded.

Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing needs to be connected to the grounding terminal.

7.LINE PHONO SWITCH – Flip this switch to select between the PHONO INPUT or LINE INPUT for each channel.

8.USB – These USB connections send and receive audio from a connected computer. The USB 1 jack can receive audio and send it to the mixer’s Channel 1. The USB 2 jack can receive audio and send it to the mixer’s Channel 2. They can also function as outputs, sending audio to your computer. For more information, refer to the USB OPERATION section.

TOP PANEL FEATURES

1.POWER LED – Illuminates when the mixer is on.

2.MASTER – This control adjusts the output volume of the Program mix.

3.MIC GAIN – Adjusts the audio level of the microphone signal.

4.CUE GAIN – Adjusts the level of the headphone audio.

5.CUE SLIDER – Slide this to mix between Channels 1 and 2 in the headphones. When all the way to the left, only Channel 1 will be heard. When all the way right, only Channel 2 will be heard.

6.CHANNEL GAIN – Adjusts the corresponding channel’s pre-fader and pre-EQ gain level.

7.CHANNEL TREBLE – Adjusts the high (treble) frequencies of the audio on the corresponding channel.

8.CHANNEL BASS – Adjusts the low (bass) frequencies of the audio on the corresponding channel.

9.INPUT SELECTOR – Selects the input source to be routed to the corresponding channel. Input jacks are located on the rear panel.

10.CHANNEL FADER – Adjusts the audio level on the corresponding channel.

11.CROSSFADER – Blends audio playing between Channels 1 and 2. Sliding this to the left plays channel 1 and sliding to the right plays Channel 2.

Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then remove the screws holding it in position. Replace the fader with a quality authorized replacement from your local Numark retailer only.

626