WIRING
All wiring must comply with local and national codes and unit must be properly grounded.
1.Run 120VAC, 60Hz supply wiring to the wall switch (not provided). The unit must be wired on a separate 20
Amp circuit.
2.Run wiring from the switch to the housing junction box. Loosen screw holding exterior wiring compartment cover and remove cover. Interior wiring compartment may be removed if necessary by loosening screw in keyhole slot in cover. Remove knockout(s) as required and install approved box connector.
3.Refer to fig. 2. Connect white wires in junction box to white (neutral) supply wire. Connect the blue wire in the junction box to the supply wire from the vent switch.
Connect the black wire to the supply wire from the light switch. Connect the red wire in the junction box to the supply wire from the heat switch. Connect green ground lead in the junction box to the supply ground.
4.Replace wiring compartment cover and tighten screw to secure.
5.Insert vent motor plug in vent receptacle on wiring compartment cover. Insert plug from heater assembly into the white socket of the wiring compartment cover.
DUCTING
1.Snap plastic duct adapter and damper assembly over flanged opening on housing. Connect 4" round duct to the duct adapter and secure with duct tape. The duct should be run to the outside of the structure through the roof or wall cap. For maximum performance keep duct runs as short and as straight as possible.
| REFLECTOR |
| REFLECTOR |
| MOUNTING |
| SCREW |
LIGHT SOCKET | FIGURE 3 |
|
HEATER JUNCTION BOX |
|
|
LIGHT | VENT | HEAT |
RECEPTACLE | ||
RECEPTACLE | RECEPTACLE | (WHITE) |
WHITE |
|
|
|
| GREEN |
WHITE |
|
|
WHITE |
|
|
|
| BLUE |
|
| RED |
| BLACK |
|
WALL SWITCH BOX |
|
|
| LIGHT |
|
| VENT |
|
| HEAT |
|
WHITE |
|
|
BLACK |
| SUPPLY |
|
| |
|
| GROUND |
120VAC LINE |
| FIGURE 2 |
|
|
MOUNTING REFLECTOR AND GRILLE
1.Place reflector in the opening in the center of the grille. The notches in the reflector should fit over the pegs on either side of the opening. Insert plug from lamp ballast into lamp receptacle on wiring compartment.
2.Place 1" screw, provided, through the center hole in the reflector and thread it into the hole in the mounting bracket running across the housing. Tighten the screw just enough to hold the grille firmly against the ceiling.
3.Install a 13 watt Compact Fluorescent lamp, NEMA type CFQ13W/GX23/827. (Not provided)
4.Snap lens into position in center of grille. To remove the lens for relamping, gently pry along the side of the lens with a screwdriver to disengage the snap in tabs while pulling down on the lens.
LENS |
|
USE COMPACT FLUORESCENT |
|
LAMP, NEMA TYPE |
|
CFQ13W/GX23/827 (PURCHASE |
|
LOCALLY) | FIGURE 4 |
|
