WIRING
Refer to Figures 5 and 6.
All wiring must comply with local codes and unit must be properly grounded.
1.Run 120vAC house wiring from power source, through wall switch, to junction box in housing.
2.To control both fan and light with one switch, install wiring.
3.For separate control of the fan and light, use NuTone double switch and install wiring.
4.Install approved box connector into wiring access hole. String wires through box connector and into junction box.
5.Use approved wire nuts to make wire connections. Green or bare supply ground lead must be connected to green lead in wiring compartment.
INSTALLATION IN EXISTING
CONSTRUCTION
PLANNING
Installing a bathroom exhaust
Plan ducting and wiring before proceeding with installation (see page 1).
CAUTION: Check area above planned location to be sure that:
(1)Ducting can be installed
(2)Wiring can be run to the planned location
(3)No wiring or other obstruction might interfere with installation
POWER/BLOWER UNIT INSTALLATION
Refer to Figure 1.
1.Place power/blower unit into housing so that mounting plate's tabs insert into slots in housing.
2.Secure mounting plate with provided screw.
3.Insert motor plug into junction box receptacle.
COMPLETING INSTALLATION
Refer to Figure 1.
1.Remove acorn nut from the threaded stud on motor mounting plate.
2.Place reflector into grille.
3.Align grille/reflector assembly with housing and insert light plug into receptacle in junction box.
4.Using acorn nut, secure grille/reflector assembly to motor mounting strap.
5.Install 100 watt (maximum) light bulb into light socket.
6.Install lens by squeezing both sides and inserting lens tabs into slots in grille.
INSTALLATION
1.The fan light can be mounted directly to a ceiling joist or spaced between joists using hanger bars (sold separately). If housing is to be mounted directly to ceiling joist plan cutout so side of housing with mounting tabs is against joist.
LOCATING JOIST: Lightly tap the ceiling. A hollow sound means no joists, a solid sound means a joist is present. To be sure you have located a joist, drill a small hole (1/16") and probe into the ceiling with a wire. Leave wire in hole to help locate it in the attic or crawl space.
2.Locate hole in attic or crawl space.
3.Using the housing as a template, mark the ceiling for the cutout. Cutout dimensions: 91/8" x 91/8".
4.Make cutout along marked line.
5.Refer to Mounting The Housing on page 2.
One Year Limited Warranty
WARRANTY OWNER:
NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
During this one year period,
The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify
Date of Installation
Builder or Installer
Model No. and Product Description
IF YOU NEED ASSISTANCE OR SERVICE - CONTACT:
Rev. 08/2007
Product specifications subject to change without notice. Printed in China., Rev. 01/08, Part No. 101256