NuTone LA-204WH Preparing The Receiver, Troubleshooting Guide, Receiver Security Coding

PREPARING THE RECEIVER

RECEIVER SECURITY CODING

Refer to Figure 5.

Changing the Security Code in not necessary unless you have changed the security code in the Pushbutton. Both the

Pushbutton and Receiver codes must match.

1.Remove the screw from the code switch cover, then remove cover.

2.Refer to Figure 6. Set the switch in the Receiver to match the jumpers in the Pushbutton. The jumpers that are installed in the Pushbutton must correspond to the switches set to the ON position in the Receiver. For example, if jumper #1 is installed, Switch #1 is in the ON position.

3.After setting the switches, reinstall the code switch cover with screw.

MOUNTING THE RECEIVER

1.Plug the Receiver into any 120 volt wall outlet. Outlet must be located within 100 feet of the Pushbutton.

PUSHBUTTON			RECEIVER
		SECURITY
		CODE SETTING
		1
		2
		3
		4
		5
		6	1	ON
			2
			3
			4
		JUMPERS	5
			6
		INSTALLED
		ON 1, 3 & 6
+	–	1, 3 & 6
		SWITCHES
SECURITY CODE		SET TO “ON”
			FIGURE 6
SETTING EXAMPLE

REMOVE

SCREW AND

COVER

FIGURE 5

TROUBLESHOOTING GUIDE

	PROBLEM	SOLUTION
1.	Chime does not sound.	• Check battery and polarity in Pushbutton.
		• Make sure Pushbutton is not located on a
		metal surface.
		• Check that outlet on Receiver has power.
		• Check Receiver and Pushbutton security
		codes. These codes must match.
2.	Chime is activated by another	• Change the security code in the
	wireless device.	Pushbutton and Receiver.
		These codes must match.
3.	When Pushbutton button is	• Check the sound code jumpers in the
	pressed, the incorrect chime	Pushbutton.
	sound is heard.

Product specifications subject to change without notice.	4820 Red Bank Road, Cincinnati, Ohio 45227
	Printed in China, Rev. 4/05, Part No. 83044