®
INSTALLATION & OPERATING INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Wireless Pushbutton
Model: LA-207TWH
MOUNTING THE PUSHBUTTON
Refer to Figures 1 and 2.
1.Locate the pushbutton next to or near the door. Do not mount the pushbutton on a metal surface. Caution: Some stucco houses have metal mesh in the wall structure which will affect the wireless chime performance.
Experiment with various positions of receiver with respect to the pushbutton to determine the location that gives best performance before mounting permanently. If not satisfied, use a wired chime.
2.Remove the pushbutton cover by inserting the tip of a screwdriver in the slot at the bottom of the pushbutton and then gently rock the pushbutton cover apart from the pushbutton base.
3.Choose a level place to locate the pushbutton base.
4.Position the pushbutton base, and mark the mounting surface with a pencil through the two holes in the pushbutton.
5.Drill two 3⁄16" diameter holes at the previously marked area.
6.Insert the plastic anchors into the 3⁄16" diameter holes.
7.Place pushbutton base over anchors, and fasten with two screws provided. Do not replace cover at this time.
8.Apply a small amount of caulking to the mounting screw holes on the base for waterproofing.
Congratulations on your purchase of a NuTone wireless chime. The chime operates by radio frequency signal transmitted by the pushbutton and received by the chime. The pushbutton/transmitter is mounted at the door. The receiver may be located anywhere in your home within 100 feet (30 meters) of the pushbutton. The pushbutton/transmitter can be programmed to sound one of three chime sounds. This feature allows up to three pushbuttons to generate three different chime sounds.
INSTALLING PUSHBUTTON COVER
1.Position the pushbutton cover over the pushbutton base so that the “lip” on the base engages into the “slot” on the cover. Make sure the rubber gasket is properly seated. Firmly press cover until it snap fits over the base.
SLOT
TO OPEN
COVER “PUSH”
FIGURE 1
PUSHBUTTON SECURITY CODING
Refer to Figure 3.
It is not necessary to change the security code of the pushbutton unless you experience interference from other wireless devices.
1.To change the security code, remove any combination of the six plastic jumper straps.
2.NOTE: Both the pushbutton and receiver codes must match.
BATTERY INSTALLATION
Refer to Figure 3.
1.Position the A23 12 volt battery as illustrated. Be sure to observe polarity
WOODEN WALL OR
DOOR FRAME
BASE
WATERPROOF
GASKET
PLASTIC
WALL
MOUNTINGANCHORS SCREWS
COVER
TOP
P.C. BOARD
SECURITY CODE
SETTING
BATTERY
LOCATION
WESTMINSTER
TWO
NOTE
LIP
ONE
NOTE
SLOT | DO NOT MOUNT ON |
|
| METAL SURFACE | FIGURE 2 |
FIGURE 3