Working Inside the Blade Server
C o m m e n t s t o u c s - d o c f e e d b a ck @ c i s c o . c o m
If you are switching from one type of adapter card to another, before you physically perform the switch make sure you have downloaded the appropriate device drivers and loaded them into the server’s operating system. For more information, refer to the firmware management chapter of one of the UCS Manager software configuration guides.
To install an adapter card on the blade server, follow these steps:
Step 1 Position the adapter board connector above the motherboard connector and align the three adapter captive screws to the posts on the motherboard. (See Figure 11, callout 1.)
Step 2 Firmly press the adapter connector into the motherboard connector. (See Figure 11, callout 2.) Step 3 Tighten the three captive screws. (See Figure 11, callout 3.)
Figure 11 | Installing an Adapter Card |
3
2
1
1
1
1
199986
Cisco UCS B230 Blade Server Installation and Service Note
| 23 |
| |
|
|
