model nsp130
damper / |
duct |
connector |
vertical duct |
knockout |
horizontal duct |
knockout |
5 Remove Vertical Duct Knockout or Horizontal Duct 
Knockout and attach Damper / Duct Connector with
two (2) screws (supplied).
Install the hood
WARNING
To reduce the risk of electrical shock, switch power off at service panel. Lock or tag service panel to prevent power from being switched on accidentally.
mounting | house |
screws (4) | power |
| cable |
| ductwork |
6 | Run House Power Cable between service panel and |
| hood location. Attach power cable to hood using appropri- |
| ate connector. |
7 | Hold the hood in position under the cabinet. Make sure |
| the damper / duct connector enters the Ductwork and |
| that the damper opens and closes freely. |
8 | Tighten the four (4) Mounting Screws completely to se- |
| cure the hood to the cabinet. |
Page
connect the wiring
green |
ground |
screw |
house |
power |
cable |
HE0059 |
9 | Connect House Power Cable to range | hood | wiring |
| - BLACK to BLACK, WHITE to WHITE, and GREEN or | ||
| BARE WIRE to GREEN Ground Screw. |
|
|
complete installation
10 
were removed in Step 3.
install light bulbs
(1) push in |
(2) rotate |
clockwise |
11 Install Halogen Bulbs. Use 120 V, 50 W, shielded halo- 
gen bulbs - MR16 or PAR16 with GU10 base. Purchase bulbs separately.
