2.When using a standard outlet box install a header between joists and securely mount outlet box to header. Using two screws supplied with the outlet box attach socket hanger securely to outlet box. Place rubber pads between hanger and box. Using 3" screws (supplied) install screws through the socket hanger mounting slots, outside of the outlet box, through the ceiling and into the header. Do not overtighten or socket hanger may be damaged. These screws serve as supplemental support independent of the outlet box.
When using a listed outlet box marked acceptable for fan support, follow instructions provided with the box.
MOUNTING THE FAN WITH DOWN ROD
1.Refer to Figure 6. To install the ball and stem assembly to the fan, feed the wires from the fan through the rubber canopy, the ceiling canopy and down rod.
2.Insert stem of rod into flange on the top of fan. (It may be necessary to back out the set screw in flange). Line up holes in stem and flange and insert smooth pin through flange and stem. Secure pin with hitch pin. Tighten set screw in flange.
3.Refer to Figure 6. Run wires from fan through
rubber cover. Lift fan and place ball hanger into socket of socket hanger. Rotate fan until groove in ball locks with tab in socket.
MOUNTING FAN WITH
CLOSE UP ADAPTER
1.Remove soft plastic bushing from the center of the ceiling cup. Secure ceiling cup to top of fan using three screws and lockwashers provided in the hardware bag. ( The down rod and ball are not required for this installation.)
2.Hang the fan from the tab on the back of the hanger bracket using one of the holes in the ceiling cup. This will support the fan while wiring connections are made.
GROOVE |
|
| TAB |
TAB | LOCKS IN |
GROOVE | |
| FIGURE 3 |
| HOUSE SUPPLY |
G W BK | WIRES |
BLACK (FAN)
WHITE (COMMON) 
GREEN 
(GROUND)
FIGURE 4
WIRING CONNECTIONS
Refer to Figure 4.
All wiring must comply with national and local codes. Be certain the power is disconnected before proceeding.
1.Connect fan wires to house supply wires using listed wire connectors. Make connections as follows: Black to black, white to white and green ground wire to green or bare copper ground from house supply.
IMPORTANT: For wall switch control use only listed general use switches.
2.After splices are made turn them upwards and carefully push into outlet box with white and green wires on one side of outlet box and black wires on the other side.
3.Using four screws (supplied) secure ceiling cup to socket hanger.
LIGHT KIT
USE ONLY
