NuTone QTXN110HL warranty Connect Wiring Install Grille & Bulbs

MODEL QTXN110HL

CONNECT WIRING

Page 3

INSTALL GRILLE & BULBS

HEAT		LIGHT
&		&
NIGHT LIGHT		FAN	VENTILATOR
RED to BLACK			HOUSING
(Heat)			RED to RED
BLACK to YELLOW
			(Fan)
(Night Light)
			BLACK to BLUE
			(Light)
WHITE to WHITE			WHITE to WHITE
WIRING PLATE	GROUND		BLACK to RED
FROM VENTILATOR
			BLACK to BLUE
WHITE
to			LIGHT (red)
WHITE
			NIGHT LIGHT (blue)
CAUTION			(3-position rocker)
			FAN (2-position rocker)
RATING SPECIFICATIONS

8. Plug-in light.

Hold grille assembly up near housing. Connect light plug from grille assembly to receptacle inside of housing.

GRILLE MOUNTING

SCREWS

• The three-position	RED	HEAT (2-position rocker)
rocker switch is rated 5 A		NuTone 4-Function
@ 125VAC. Use this switch
for Lights ONLY.	120 VAC LINE IN	Control shown
		(purchase separately)
• Each two-position rocker	BLACK to BLACKS

switch is rated 15 A @ 120VAC. Use these switches for Heat and Vent.

• The total load on this control must not exceed 20 A @ 120VAC.

5. Connect electrical wiring.

Run 120 VAC house wiring to installation location. Use proper UL approved connectors to secure house wiring to wiring plate. Connect wires as shown in wiring diagram(s).

INSTALL GRILLE & BULBS

6. Finish ceiling.

Install ceiling material. Cut out ceiling material closely around housing.

7.Remove light lens

from grille.

Insert a small flat- bladed screw- driver into the slot at one end of the light lens. Carefully pry the lens out.

9. Attach grille.

Remove the (2) grille mounting screws from the sides of the housing. (See Step 8 illustra- tion.) Use these screws to attach the grille to the housing as shown.

To avoid damage to the grille: DO NOT OVERTIGHTEN SCREWS. Tighten screws only until grille is snug against ceiling material.

10. Install bulbs.

The unit accepts (2) 60- Watt (maxi- mum) incandes- cent bulbs and

(1) 7-Watt night light bulb.

11.Attach light lens.

Hook the tabs on one end of the lens into the slot in the grille. Lift other end of lens up and snap into place.