®
PREPARE THE HOOD
3 Remove
Damper/Duct Connector from inside the hood. Set connector aside - with mounting screws and parts bag.
DAMPER/DUCT
CONNECTOR
4 Remove
Wiring Cover from inside the hood. Set cover and mounting screw aside.
WIRING
COVER
5 Remove either top or back
wiring knockout and install approved
Electrical Cable
Clamp.
ALLURE™ WS1 SERIES
RANGE HOOD
Page 3
PREPARE THE HOOD
AIR CHUTE
7 | Remove Air |
| Chute - held in |
| place with one |
| (1) screw. |
NOTE: Be careful not to disconnect any wires.
8 | Remove Baffle |
| from air chute. |
➙ BAFFLE
BAFFLE ➙
ELECTRICAL CABLE CLAMP
Non-Ducted Installation - Skip to “Connect Wiring” section.
| (3) #8 SCREWS | LIGHT |
| PANEL | |
The following |
| |
|
| |
Steps (6 thru | (2) #8 SCREWS |
|
13) are for |
| |
|
| |
DUCTED |
|
|
INSTALLATION |
|
|
ONLY. |
|
|
6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
9 |
10
➙
Rotate baffle. Reinsert baffle into air chute (as shown) so that baffle tabs fit all the way into slots in air chute. An audible “click” will be heard when fully installed. This will close off the air flow through the
SLOTS
➙
NOTE: Be careful not to trap wires between support fin and light panel.
TABS
➙
SUPPORT FIN