|
|
|
|
| ALLURE™ WS1 SERIES |
|
|
|
|
| RANGE HOOD |
|
|
|
|
|
|
|
| ® |
|
|
|
|
|
|
|
| |
|
|
|
| Page 5 | |
|
|
|
|
| |
| INSTALL HOOD |
|
|
| KEYHOLE |
| (4) |
| MOUNTING |
| SCREW |
| (4) |
1 Hang hood from (4) Mounting Screws (from parts bag). Slide | |
hood towards wall until mounting screws are engaged in | |
narrow end of (4) Keyholes. Tighten mounting screws | |
securely. |
|
CAUTION | DO NOT PUSH ON FAN BLADE. Pushing on the |
| blade may cause it to interfere with other hood parts. |
| DUCT |
| TAPE |
2 Connect ductwork to hood. Use Duct Tape to make joints secure and air tight.
PAR20,
50W MAX.
HALOGEN
BULB (2)
- or - R16, 40W MAX.
INCANDESCENT
BULB (2)
If hood is to be installed
Purchase a set of (2)
OPERATION
Fan: The
Light: The
CLEANING
WARNING: To reduce the risk of electric shock, disconnect from power supply before cleaning.
Aluminum mesh filters: Clean frequently using hot water and a mild detergent. Filters are dishwasher safe.
Charcoal filters: Clean filter surfaces frequently with a damp cloth and a mild detergent. DO NOT immerse filters in water or put in dishwasher. The special “Clean Sense” feature indicates when the filter is to be replaced. The blue and yellow strips will blend to green when it is time to change the filter. The “Clean Sense” fea- ture works best when facing toward the cooking surface.
To clean hood: Remove filters. Use a damp cloth and a mild deter- gent to wipe all
Motor is permanently lubricated. Do not oil or disassemble motor.
3 |
Install (2) PAR20, 50 W Maximum Halogen Bulbs or (2) R16, 40 W Maximum Incandescent Bulbs. Purchase bulbs separately.
!CAUTION: Bulbs may be hot! Refer to bulb packaging for further information.
4 |
Replace filters and make sure fan blade turns freely. Turn on power at service panel, and test for proper operation.