ALLURE™ WS1 SERIES RANGE HOOD

PREPARE THE HOOD

TOP RECTANGULAR

 

DUCT KNOCKOUT

SEMI-CIRCULAR

(Remove for 3¼” x 10”

DUCT KNOCKOUT

Vertical & for 7” Round

(Remove for 7” Round

Discharge)

Discharge)

 

REAR

RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10” Horizontal Discharge)

11Remove appropriate Duct Knockout(s) from top or back of hood.

UP TO 1”

TAPE

TOP/BACK

EDGE

SIDE-TO-SIDE

 

 

ADJUSTMENT

 

 

PIVOT

DAMPER/DUCT

 

 

CONNECTOR

 

(Vertical discharge

 

position shown)

12 3¼” x 10” Ducted Discharge Only: Attach Damper/Duct Connector over knockout opening. Make sure damper Pivot is nearest to Top/Back Edge of hood. Remove Tape from damper flap.

137” Round Ducted Discharge Only: Re-install 7” Round Duct Plate removed in Step #1 under “PREPARE THE HOOD” section. Install a 7” round damper (purchase separately). Damper flap must open freely in direction of air flow (away

from range hood).

NOTE

To accomodate off-center ductwork, the Damper/Duct

 

Connector can be installed up to 1-inch on either side of

 

 

hood center or the 7” Round Duct Plate can be installed

up to ½” on either side of hood center. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

Page 4

CONNECT WIRING

WARNING: To reduce the risk of electric shock, make sure power is switched off at the service panel. Lock or tag service panel to prevent power

from being switched on accidentally.

HOUSE WIRING (120 VAC)

CARDBOARD (Use to protect cooktop)

1Connect House Wiring (120 VAC) to hood. Use a piece of Cardboard to protect the cooktop, if necessary.

GREEN

GROUND

SCREW

2Connect house black to hood black wire, house white to hood white wire, and house ground under Green Ground Screw.

Securely tighten cable clamp onto house wiring.

3 Replace wiring cover.

Page 4
Image 4
NuTone WS1 SERIES, WS130AA warranty Connect Wiring