NuTone Prepare The Hood, ALLURE WS2 SERIES, Range Hood, Page, The following, Steps 6 thru

		ALLURE® WS2 SERIES
		RANGE HOOD
	®
		Page 3
PREPARE THE HOOD		PREPARE THE HOOD

3	Remove
	Teflon®-coated
	bottom cover
	from hood. Set
	cover and
	mounting
	screws aside.

Teflon® is a registered trademark of DuPont.

4 Remove

Damper/Duct Connector from inside the hood. Set connector aside - with mounting screws and parts bag.

DAMPER/

DUCT

CONNECTOR

5 Remove either top or

back wiring knockout and install approved

Electrical

Cable Clamp.

TEFLON®-COATED BOTTOM COVER

(Held in place with 2 screws)

AIR CHUTE

7	Remove Air
	Chute - held in
	place with one
	(1) screw.

NOTE: Be careful not to disconnect any wires.

8	Remove Baffle
	from air chute.

➙ BAFFLE

BAFFLE ➙

➙

ELECTRICAL CABLE CLAMP

Non-Ducted Installation - Skip to Step 15.

	(3) #8 SCREWS	LIGHT
		PANEL
The following
Steps (6 thru	(2) #8 SCREWS
14) are for
DUCTED
INSTALLATION
ONLY.

6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

9

10

Rotate baffle. Reinsert baffle into air chute (as shown) so that baffle tabs fit all the way into slots in air chute. An audible “click” will be heard when fully installed. This will close off the air flow through the non-ducted slots on top of hood.

SLOTS

➙

Re-install air chute, re-connect wire harness, and replace light panel.

NOTE: Be careful not to trap wires between support fin and light panel.

TABS

➙

SUPPORT FIN