NuTone WS3 Prepare Hood Location Prepare Hood Location, Prepare The Hood, 3¼” X 10”, Page, Center

ALLURE® WS3 SERIES

RANGE HOOD

®

Page 2

PREPARE HOOD LOCATION PREPARE HOOD LOCATION

ROOF CAP	3¼" X 10" or
	7" ROUND DUCT
	(For vertical
	discharge)

7” ROUND

VERTICAL DUCTING

SOFFIT

	HOUSE WIRING
CABINET	(Top or Back of hood)

WALL CAP

HOOD

24" - 30" ABOVE	3¼" X 10" DUCT
COOKING SURFACE
	(For horizontal discharge)

1 Determine whether hood will discharge vertically (3¼” x 10”						3 Run house wiring between service panel and hood location.
or 7” Round), or horizontally (3¼” x 10” only). For vertical or
horizontal discharge, run ductwork between the hood loca-
tion and a roof cap or wall cap. For best results, use a mini-
mum number of transitons and elbows.						PREPARE THE HOOD
2 Use diagrams, below, for proper placement of ductwork and
electrical cutout in cabinet or wall. For a non-ducted installa-
tion, DO NOT cut a duct access hole.						7” ROUND
HOOD MOUNTING SCREWS (4)				3¼” X 10”		DUCT PLATE
			VERTICAL DUCTING
1315/16" (30" hood)
		1315/16" (30" hood)
1615/16" (36" hood)
1915/16" (42" hood)		1615/16" (36" hood)
CABINET FRONT		1915/16" (42" hood)
		7½"
	CABINET BOTTOM
	5¼"	5¼"		2"	10½"
	VERTICAL DUCT
5"	ACCESS HOLE
	1¼"				1½"

		ELECTRICAL
WOOD SHIMS		ACCESS HOLE
	CENTER
(recessed-bottom		(in cabinet bottom)
	LINE
cabinets only)

1

Remove 7” Round Duct Plate from top of hood. Set duct plate aside - with mounting screws.

WOOD SHIMS			3¼” X 10”
(recessed-bottom		HORIZONTAL DUCTING
cabinets only)	CABINET FRONT
			1/8" ¾"
3¾"	HORIZONTAL DUCT
	ACCESS HOLE
CABINET
	5¼"	5¼"
BOTTOM
1315/16" (30" hood)		7½"
		1315/16" (30" hood)
1615/16" (36" hood)
		1615/16" (36" hood)
1915/16" (42" hood)
		1915/16" (42" hood)
HOOD
MOUNTING	CENTER		ELECTRICAL
			ACCESS HOLE
SCREWS (4)

LINE (in wall)

FILTERS

2 Remove tape holding Filters in place. Pull down on filter tabs or finger holes and lift filters out. Set filters aside.