Actual use of these data fields is not regulated, and
they may vary significantly in content between
stations. If you choose not to have RDS information
displayed, pressing the “Display” button will then
indicate “RDS receive OFF”. In this state, Stereo
indication and a signal strength indicator will replace
the PSN field on the top line, and only the station
frequency will be displayed on a connected zone's
Display Pad. Pressing the button again will restore
RDS and display “RDS receive ON.” Each press of the
“Display” button toggles between on and off.
Signal Strength/Stereo Indicator
The signal strength indicator responds to the field
strength of the received carrier signal, fig. 24. This
indicator has seven discrete levels, with a single point
at the bottom of the character space indicating a
signal just detectable by the tuner, and a very strong
signal indicated by four lines of increasing length
above 3 dots. Stereo indication is also provided when
the tuner is successfully decoding FM Multiplex
stereo stations. The field will be blank if stereo
reception is not possible due to weak signal
conditions or if the station is broadcasting in
monaural (mono). The field will display MONO if
Force Mono is enabled from the MENU. This indicator
and Stereo lock information will be displayed upon
tuning to a new station. If RDS Receive is ON (see
previous section), then the indicator and Stereo lock
information will be displayed momentarily until valid
RDS PSN data has been received; then it will be
replaced by that data.
Using the Memory Feature
Memory is used to store a specific display for future
reference. This is useful for referencing specific RDS
or XM information later. It can be used for viewing a
song title and artist that you might need to recall at a
later date. By pressing the “Memory” button with a
single tap, whatever information is scrolling on the
display at that time will automatically be saved in the
first memory position.
PUSH TO
ENTER
SELECT
Tuner A
102.7 Stereo
WXYZ
FM STEREO•AM•WEATHER
-–-
–
---
-
-
-
–
–
–
–-
Fig.24
Fig. 25
Model NV-T2DF
Dual FM/AM/WX Tuner
REMOTE
SENSOR
PUSH TO
ENTER
SELECT
1
6
2
7
3
8
4
9
5
0
<
<
DISPLAYMEMORY MENU PRE/DIR SOURCE ON-OFF
CATEGORY PRESET/DIRECT
Tuner A
STANDBY
FM STEREO•AM•WEATHER
102.7 Rockin
Display Saved
Page 19
Pressing and holding the Memory button puts the T2
in memory recall mode. Turning the Select knob will
scroll up through the saved displays, starting with the
most recently saved. The T2 has the ability to save up
to 10 displays. When a new display is saved, it will
automatically place that information in the first slot,
and bump all previously saved displays down one.
Display number 10 will automatically drop off the list,
fig. 25.
Source Switching
Pushing the “Source” button scrolls between AM, FM,
WX (Weather Band), and Auxiliary (Aux.) modes. The
auxiliary mode is optional and must be turned on
through the T2 Configuration software (see NV-T2DF
Configuration software, advanced settings, pg. 24) or
through the advanced settings menu accessed at the
front panel (see Front Panel Menu Controls).