Mainboard nForce 680i SLI/

Mainboard nForce 680i LT SLI

Rebuilding a RAID Mirrored Array

This section will illustrate how to replace a failed drive with a new one, and rebuild the array to restore lost data on the newly installed drive. Rebuilding only applies to fault-tolerant arrays which are RAID 1, RAID 0+1, and RAID 5 arrays.

1.Before rebuilding an array, you must connect new hard disk(s) onto your computer.

2.Power on your computer. When the system boots up during the POST (Power-On Self Test), you will be given an opportunity to enter the NVIDIA RAID Setup Utility when the screen prompts you with the following message.

“Press ＜F10＞ to enter RAID setup utility…”

3.Press <F10> key to enter the NVIDIA RAID Setup Utility (note that you will only have a short window of time to press <F10> before the system continues the next step of the boot process).

4.Go to the screen shown as below. Press <Enter>.

64