NXP Semiconductors UM10044
ISP1183 Low-Power USB Peripheral Controller PC Eval Kit
5. Installing hardware, firmware, INF and driver The procedure to install hardware, firmware, INF and driver is as follows:
1. Switch off the periphe ral PC.
2. Remove all unnecessary cards on the peripheral PC.
3. Plug the ISP1183 eval board in the ISA slot of the peripheral PC.
4. Switch on the peripheral PC.
5. On the peripheral PC, under the DOS mode, run firmware 1183FW.EXE.
If it is the first time that the eval board is connected to the host PC, the host OS Device
Manager will prompt for the installation of INF and drivers.
6. Select the location of D13TEST.INF and D13TEST.SYS from the ISP1183 evaluation
diskette and complete the installation procedure.
6. Using the host applet Test applet D13TEST.EXE exercises all the ISP1183 endpoints as shown in Fig 3.
Fig 3. D13Test applet
Table 9 shows a description of endpoints operation on the ISP1183 eval board.
UM10044_4 © NXP B.V. 2007. All rights reserved.
User manual Rev. 04 — 6 February 2007 6 of 18