NXP Semiconductors ISP1183

NXP Semiconductors UM10044

ISP1183 Low-Power USB Peripheral Controller PC Eval Kit

4. In dialog box Device Framework Tests, as seen in Fig 5, deselect Perform Remote

Wakeup and select In A Continuous Loop.

5. Click the Start Automated Testing button.

The Full Test Results dialog box appears, as seen in Fig 6.

6. To stop the loop test, click Stop Testing.

Fig 6. Full Test Results dialog box

The USBCV testing tool can be downloaded from the USB website. Check the website

for the latest version of the tool.

User manual Rev. 04 — 6 February 2007 9 of 18

Contents

Main UM10044 ISP1183 Low-Power USB Peripheral Controller PC Eval Kit Rev. 04 6 February 2007 User manual Contact information 1. Introduction 2. System requirements NXP Semiconductors UM10044 3. Jumper settings on the ISP1183 eval board 4. I/O mapping 5. Installing hardware, firmware, INF and driver 6. Using the host applet 7. Testing control endpoints using standard USB compliance tool Page Page NXP Semiconductors UM10044 8. Schematics V(1V8) Power supply module Fig 7. Power supply module 1 2 ISP1183 Low-Power USB Peripheral Controller PC Eval Kit ISP1183 DATA2 23 Fig 9. ISP1183 USB module CPLD module VCCINT 57 69 84 Fig 10. CPLD module ISA interface module Fig 11. ISA interface module VCC Indicator module Fig 12. Indicator module RESET 9. Bill of materials User manual Rev. 04 6 Feb ruary 2007 14 of 18 Page ISP1183 Low-Power USB Peripheral Controller PC Eval Kit 10. References 11. Legal information 11.1 Definitions 11.2 Disclaimers 11.3 Trademarks 12. Contents