88 - C110 User’s Guide
Error Messages
These messages indicate errors which you must correct before a print job
can continue or the printer status return to “Ready”.
Ready
indicator
(green)
Attention
indicator
(orange)
Toner
indicator
(orange)
Condition Action
Off Rapid
blinking On Toner out
» Note: This
message
appears when
the Toner Out
Stop in the
Remote Panel
Utility is set to
On.
Replace the toner cartridge.
»Note: If Toner Out
Stop in the Remote
Panel Utility is set to
Off, printing can
continue.
However, the printing
results are not
guaranteed.
Off On On The toner cartridge is
not installed. Install the all toner
cartridges.
Toner empty Replace the toner cartridge.
Slow
blinking Slow
blinking *Media empty Load media into Tray 1.
Slow blinking
alternately *Media size error
The size of paper
being printed on is
different from the
size of paper
specified in the
printer driver.
Press the Cancel key to
cancel the error.
To print on paper of the size
specified in the printer
driver, load paper of the
correct size into Tray 1, and
then try performing the print
job again.
Off Slow
blinking *Memory full Press the Cancel key.
If the error is not corrected,
turn off the printer. After a
few seconds, turn on the
printer.
Off Blinking *Front cover or top
cover is open. Close the front cover and
top cover.
*The imaging
cartridge is not
installed.
Install the imaging
cartridge.