143 - C130n User’s Guide
Printing
takes too
much time.
The printer is set to a slow
printing mode (for example,
thick stock).
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The printer is set to power
saving mode. It takes time for printing to start in
power saving mode.
The job is very complex. Wait. No action needed.
A toner cartridge for a
different region is installed
(X INCORRECT is
displayed in the message
window).
Install a genuine Oki toner cartridge
approved for your specific printer.
Blank pages
are printed. One or more of the toner
cartridges are defective or
empty.
Check the toner cartridges. The image
will not print correctly or not at all, if a
cartridge is empty.
The wrong media is being
used. Check that the media type set in the
driver matches the media loaded in the
printer.
Printer
returned to
IDLE before
the
configuration
menu was
changed.
The printer was in the
configuration menu structure
without a selection being
made within two minutes.
When in the configuration menu
structure, select your choice within
2 minutes.
Not all pages
print. The Cancel key was
pressed. Make sure no one pressed the Cancel
key while your job was printing.
The tray is empty. Check that the tray is loaded with
media, in place, and secure.
A document is printed with
an overlay file which has
been created by a
non-suitable driver.
Print the overlay file using a suitable
driver.
Printer
resets or
turns off
frequently.
The power cord is not
correctly plugged into the
outlet.
Turn off the printer, confirm that the
power cord is correctly plugged into the
outlet, and then turn on the printer.
A system error occurred. Contact Technical Support with the
error information.
Symptom Cause Solution