Microline 8480FB User’s Guide
Set Top of Form (TOF) • 60
6. Store the TOF position in the printer’s memory:
a. To store the position as the 1Chr. Set Pos setting,
press the SEL switch. The setting will be retained, even if
you turn the printer off, until you use this procedure to
change the setting. This also automatically sets the TOF
setting in the Manual Feed group to 1Chr. Set Pos.
Note If you reset the printer to the factory defaults, the 1Chr.
Set Pos you have established will be deleted.
b. To store the position in the printer’s memory only
until it is turned off or receives an I-Prime signal,
press the LOAD switch.
7. Press SEL to return the printer to the on-line state.
Temporary TOF

Use the Control Panel

This TOF setting applies only to the sheet or continuous form loaded
into the printer when the setting is made. The next sheet or form
feeds to the selected default TOF.
1. With paper loaded in the print path, press SEL to put the printer
offline.
2. Change the location of the first line of printing:
a. To move the TOF further down on the page (print paper
advances further into the printer):
– In 1/180-inch increments: press and hold the SHIFT
switch, then press FF.
– One line at a time: press FF.
b. To move the TOF further up on the page (print paper retracts
further out of the printer):
– In 1/180-inch increments: press and hold the SHIFT
switch, then press LF.
3. Press SEL to return the printer to the on-line state.
4. Send the print job.