Loading Paper
Your printer has three print paths:
•Rear Feed for continuous forms (see below)
•Top Feed for single sheets (see “Loading
•Bottom Feed— requires optional pull/push tractors— for thick
Loading Rear Feed Paper
1Move the paper lever (1) to the REAR position.
1
2Lift up the paper separator.
3 Load the paper on the tractors: pull levers (1) to unlock, open covers (2), place paper holes on pins (3), close covers, adjust distance between tractors and push levers back to lock.
1 3
2
4Close the paper separator.
5Place the wire guide (1) on the
1
2
6Press FF/LOAD (1).
|
|
|
| 1 |
|
SEL |
|
|
|
|
|
SEL |
| LF | FF/LOAD | TEAR | PARK QUIET |
MENU | SHIFT | Micro Feed | Micro Feed |
| TOF |
|
| Down | Up |
|
|
EXIT |
| GROUP | ITEM | SET | |
POWER | ALARM | MENU |
|
|
7Check the Top of Form (see below).
Important Notes
Regarding the Top of Form (TOF) Setting
The Top of Form is where the printing begins on the page. The factory setting is 1 inch down from the top of the page.
!If you turn the platen knob when the printer is on, you will cause the Top of Form to
!Use the red line on the plastic paper shield (1)
on the printhead as a |
|
guide to where the first | 1 |
line will print.. |
!The Top of Form and Forms
•Forms Tear-Off set to OFF (factory setting):
1.Press SEL to take the printer offline.
2.Press and hold SHIFT while pressing the LF (to set TOF higher on page) or FF/LOAD (to set TOF lower on page).
3.Hold SHIFT and press QUIET/TOF several times to save the setting, then press SEL.
•Forms Tear-Off set to ON:
1.Press SEL to take the printer offline, then press TEAR to go to current TOF.
2.Press and hold SHIFT while pressing the LF (to set TOF higher on page) or FF/LOAD (to set TOF lower on page).
3.Hold SHIFT and press QUIET/TOF several times to save the setting, then press SEL.
!Your software may print the first line above or below where the Top of Form (TOF) is set. If this happens, adjust the TOF so that it is correct for your software.
2