Oki VK2000 instruction manual Getting Started, Speech LSI Panel

Semiconductor VK2000

6. GETTING STARTED

Connect VK2000 firmly to a free serial port of the PC. Double-click on the program icon to start the control software which will come up with the screen pictured below for the selection of the serial port.

By default, COM1 is selected. Any valid selection you make will be stored in an initialisation file and be available at next start up. Before going further, please make sure that the serial cable is properly connected to both VK2000 and the host. Then engage power to VK2000 and push the Reset button briefly before you click on the START button.

NOTICE

When using a laptop or notebook, noise may interfere from the AC adapter. In such an event please run on the battery.

The recording devices, ML2500, MSM9841 and MSM9888L have no pre-recorded samples associated with them. Please record first before you click on a playback button.

7. THE SPEECH LSI PANEL

The LSI panel is the working screen. The control software is so designed as to provide a panel on which each LSI can be selected and activated simply by a mouse click. Please refer to the following pages for more information.

Commonly used by all LSI modes are the optical symbols for REC, PLAY and PAUSE, which come on and go off in accordance with a current selected mode.

RECORDING PLAYING BACK REC/PLAY PAUSED

Adjust the audio volume using the variable resistors VR1 for the left speaker output and VR2 for the right speaker output.

Page 3/11