Olympia CM1830 manual

Quick Reference CM 1830 Cash Register 5/621/3300 (13)

This quick reference only provides basic information.

For more detailed information, please refer to the Operating Instructions manual.

Insert paper roll

Connect the cash register to the power supply. The message ¹￿º» appears in the display and an acoustic signal is issued. Press the mkey to stop the acoustic alarm. Open the printer lid. Set the key-operated switch to R. Insert the paper rolls (37 mm width) for the receipt and journal in the paper holders. Do not use recycled paper. This causes the printer to wear more quickly. Prepare the paper rolls for insertion. Unroll the first layer and cut the end of paper straight. This prevents a paper jam occurring. The end of the paper rolls must be at the bottom. The journal paper must be fed over the end of paper sensor as illustrated below. Insert the end of the paper roll, cut straight, into the printer mechanism and press <(receipt) or <(journal) accordingly, until approx. 10 cm has been fed through. Depending on the roll used, feed the paper past the tear-off edge on the printer lid or onto the paper reel. Close the printer lid. Press the 6key.

Paper reel

The paper reel is required when the journal paper should be rolled onto it.

1.Open the printer lid.

2.Remove the paper reel.

3.Thread the end of the journal roll in the slit of the paper reel.

4.Insert the paper reel in the reel guides provided for it.

5.In order to remove the journal paper after it has been rolled up on the reel, remove the paper reel and pull the journal paper roll off.

6.Reinsert the paper reel.

7.Close the printer lid.

Change ribbon cassette

Note: Only use original ribbons.

1.Open the printer lid

2.Pull the ribbon cassette up and out using the grip provided.

3. Insert the new ribbon cassette in the printer so that the ribbon is positioned between the print head and paper. Latch the ribbon cassette in place by pressing lightly.

4. Tighten the ribbon by turning the wheel in the direction of the arrow.

5. Close the printer lid.

Key-operated switch

The key should be set to position R (Registration) for normal operation.

Off	Registrations	X-reports (without	Z-reports (with	Programming	Training
	(normal operation)	memory deletion)	memory deletion)

Note: Loss of data and blocking of the cash register are possible in operating modes Z and P. Only use these modes when you are familiar with programming and operating the cash register.

Olympia 09.2001 Page 1 All rights reserved.