Wipe the inside of the Case with a soft cloth not causing any fibers. Remove the
Ｑ６：How should I take pictures under water?
Ａ６：Please observe the following items for shooting under water. （1）Fix the protector with the accessory hand strap to your wrist.
（2）When you place a finger onto the lens window, the finger will appear in the photo. Pay attention to the position of your fingers when holding the Case.
（3）When pressing the shutter lever, hold the Case securely with both hands and operate the lever quietly to prevent camera shake.
（4）Look through the LCD monitor window on the rear of the Case to confirm the picture and then press the shutter lever. Please note that the optical viewfinder cannot be used, When the LCD monitor is used, the battery is exhausted earlier. In order to avoid losing shutter chances due to an exhausted battery, you should always replace a battery with a fully charged battery before each dive.
Ｑ７：How can I check for water leakage?
Ａ７：For confirmation, perform the advance test and the final test after loading the camera. The advance test with immersing the Case without the camera to the intended use depth to check for water leakage is the most accurate test, but when this is difficult, it is safer to perform this test even at a depth of 1 m or in a bathtub. The final test also can be performed in a bathtub or a bucket.
Ｑ８：What are the causes for entry of water?
Ａ８：The main causes for the entry of water are shown below. Please check them most carefully.
（1）Forgetting to install the
（2）The
（3）Damage, deterioration, or deformation of the
（4）Sand, fibers, hair or other foreign matter on the
（5）Sand, fibers, hair or other foreign matter on the
（6）Catching of the strap, the bag of silica gel, etc. at the time of sealing the
