Replacing the Batteries:

When [N] appears on the display, replace the batteries as soon as possible. Size-AAA alkaline batteries are recommended. When the batteries are depleted, [O] appears on the display, and the recor-der shuts off.

•To replace the battery, make sure that you set the HOLD switch to the opposite direction of the arrow before replacing.

hPower Supply

Poweron:SlidetheHOLDswitchinthedirection
opposite that indicated by the arrow. Power off: Slide the HOLD switch in the
direction indicated by the arrow while the recorder is not in operation.
Standby Mode and Display Shut Off:

If the recorder is stopped for 5 minutes or longer during recording or playing, it goes into Standby (power-save) mode, and the display shuts off. To exit Standby mode and turn on the display, press any button.

hHold

Setting the HOLD switch to the direction of the arrow holds the current status, and all button operations are disabled. Remember to release the HOLD switch to use the recorder.

hSetting Time and Date [Time & Date]

If you have set the time and date, information as to when a sound file was recorded is stored automatically with that file.

When you install batteries for the first time or each time you replace the batteries, the “Month” indication will flash. In such a case, be sure to set the time and date by following steps 4through 6described below.

1Press and hold the DISP/MENU button for 1 second or longer to go to the main menu.

2Press the 9or 0

 

button to select

 

[Sub Menu].

 

3Press the PLAY/OK (`)

Time & Date

button.

• [Time & Date] appears on the display, and [\^]] flashes.

4Press the 9 or 0 button to select the item to set.

•Select the item from “Month”, “Day”, “Year”, “Hour” and “Minute” with a flashing point.

5Press the +or – button to set.

•Follow the same steps by press- ing the 9or 0button to elect the next item, and press the + or – button to set.

6Press the PLAY/OK (`) button to complete the setup screen.

•The clock will start from the set date and time.

•Press the PLAY/OK (`) button according to the time signal.

1.1‘08 12:00AM

1.1‘08 12:00AM

7.25‘08 3:00PM
7Press the STOP (4) button to close the menu mode.

• This completes the time and date setup procedure.

Notes:

•You can choose between 12 and 24 hour display by pressing the DISP/MENU button while setting the hour and minute.

•You can change the order of the date indication by pressing the DISP/MENU button while you are setting the year, month, or day.

- 3 -