Omega Engineering M0102, M0902 instruction sheet Introduction, Unpacking Instructions

MODEL J DIALTEMP™

150

®

50 200

0 250

INSTRUCTION	M0102/0902
SHEET

INTRODUCTION

The Model J DialtempTM is a non electronic thermometer that features a 360 degree swivel neck with a 90 degree tilt range of it’s large easy-to-read 5 inch dial face. The heliarc stainless steel welded construction provides a moisture-proof bond, while preventing the possibility of rust and corrosion. The temperature sensing device consists of sensitive bi-metal coils. They are wound to pre-determined standards and are individually trimmed and tested for full-scale accuracy, contributing minimum pointer vibration and maximum heat transfer. One external reset screw enables fast and simple recalibration. This superior DialTemp instrumentation design combines high precision with durability and dependability, making the Model J Thermometer ideal for a wide variety of applications.

UNPACKING INSTRUCTIONS

Remove the packing list and verify that all equipment has been received. If there are any questions about the shipment, please call the OMEGA Customer Service Department at 1-800-622-2378 or (203) 359-1660.

Upon receipt of shipment, inspect the container and equipment for signs of damage. Take particular note of any evidence of rough handling in transit. Immediately report any damage to the shipping agent.

N O T E

The carrier will not honor any claims unless all shipping material is saved for their examination. After examining and removing contents, save packing material in event reshipment is necessary.

HEAD ADJUSTMENT INSTRUCTIONS

Adjust the angle of the head before installing the Model J Thermometer. Refer to Figure 1 to locate the adjustment screws.

N O T E

Install the thermometer so that the maximum ambient head temperature remains below 300°F (149°C) at all times.

1.Adjust the rotational position of the head by loosening the two bracket bolts and rotating the bracket until the head is in the desired position.