Omega Engineering PSW1000 Cdly, Min, Clrl, Offs, Cut, Dlds, Errc, Lith, Aozs, Aofs, Stno, Code

PSW1000.qxp 6/5/2008 3:45 PM Page cov-7

CDLY	0,0s...9,9s	Time setting to delete the maximum value memory after
		switching point SP1 is reached (manual deletion is still possible)
MIN	-1 ... xxxx	Display of peak value “Min”
CLRL	-----	Delete the minimum value memory
		-----	no deletion
		clr	delete value
OFFS	-9,9 ...+xx	Measured value offset in bar
CUT	0,0 ... +xx	Cut-off. e.g. signal suppression at measuring range start in bar
DLDS	0,0 ... 9,9s	Time delay for currently displayed value in seconds
ERRC	-----	Error messages:
		0:	-ok-	no error
		1:	max	exceeding pos. measuring range
		2:	min	exceeding neg. measuring range
		3:	dig1	switching output 1 error
		4:	dig2	switching output 2 error
		5:	anao	analog output error
		6:	sens	sensor error
		7:	data	data error (EEProm)
		8:	prog	program error
		9:	cal	calibration error
V7.X	Lev0...Lev2	Programming lock:
		Version display with actual input level:
		0 :	only display of operating parameters, no changes possible
		1 :	only switching points can be set (“max“ and “min“
			memories)
		2 :	release user level (all operating parameters for customer)
LITH	20 ... 100	Change display brightness 20...100%
		(only for units with Dot-Matrix display)
AOZS	0 ... 9999	Scale the analog output - start value (e. g. 0 bar = 4 mA)
(only V7.X)
AOFS	0 ... 9999	Scale the analog output - end value (e. g. 400 bar = 20 mA)
		(output signal start value always corresponds to the display ini-
		tial value, e. g. 0 bar = 4mA)
		Maximum turn-down 4 : 1, i.e. at values below 25 % of the mea-
		suring range the analog output is switched off
STNO	-----	Enter the station number at Profibus DP
RECL	-----	SHRT	short profile 8 byte
		LONG long profile 32 byte
				selection of the Profibus-protocol
CODE	000...999	Enter the code level: Changes:
		Lev1:	471	(up + down five seconds) Lev1-Lev0
		Lev2:	740	(up + down + M five seconds) Lev2-Lev0
		Lev0:	999
OPT	-----	Display of the unit options
(onlyV7.X)

5