Omega Engineering PSW1000 manual Dialog item Value Description

PSW1000.qxp 6/5/2008 3:45 PM Page cov-6

List of functions:			(xxxx = 125% f. s.)
Dialog item	Value	Description
MENU	-1...9999	Primary display, e.g. the value selected in the DISP menu appears
DISP	.....	Display value which should be permanently in the display:
		act	actually measured value
		sp1	switching point SP1
		sp2	switching point SP2
		max	maximum peak value
		min	minimum peak value
ACT.	-1...9999	Display of actually measured value in bar
UNIT		Fixing the unit
	bar	bar = bar		The unit is shown in the display appr.
	psi	psi x = psi x 10		every 30 sec. for appr. 5 sec.
	psi	psi	= psi
	HPa	HPa	= Hekto-Pascal
	mbar	mbar	= millibar
SP.1	.....	none	switching output deactivated
		wind	window technology
		stnd	standard evaluation SP2
		erro	error output
ON-1	-1 ... xxxx	Switch-on point for SP1; if the ON value is smaller than the OFF
		value the switching point evaluation is falling
OFF-1	-1 ... xxxx	Switch-off point for SP1
DLY1	0,0s...9,9s	Switch-on / switch-off delay for SP1 in seconds
INV-1	.....	Inversion of switching output SP1
		hlfs	high-level-fail-save (normally open function)
		Ilfs	low-level-fail-save (normally closed function)
SP.2	.....	none	switching output deactivated
		wind	window technology
		stnd	standard evaluation SP2
		erro	error output
ON-2	-1 ... xxxx	Switch-on point for SP2;
		if the ON value is smaller than the OFF value
		the switching point evaluation is falling
OFF-2	-1 ... xxxx	Switch-off point for SP2
DLY2	0,0s...9,9s	Switch-on / switch-off delay for SP2 in seconds
INV-2	-----	Inversion of switching output SP2
		hlfs	high-level-fail-save (normally open function)
		Ilfs	low-level-fail-save (normally closed function)
MAX	-1 ... xxxx	Display of peak value „Max“ (xxxx: = max. 125 % f. s.)
CLRH	-----	Delete the maximum value memory
		-----	no deletion
		clr	delete value

4