Omega Speaker Systems Metal Liner and Decorative Wood Hood installation instructions

I M P O R T A N T

INSTALLATION INSTRUCTIONS FOR

OMEGA INDUSTRIES, INC.’s

METAL LINER AND DECORATIVE WOOD HOOD

Before installation may begin, the following components are required: •Fan unit, part number 90026WHI1

•Blower unit, part number 90039WHI1

•Ducting System • Metal Liner • Decorative Wood Hood

A. The Wood Hood is composed of three separate components:

1. The decorative Hood Front.

2. Optional galley rail (shipped unattached).

3. T-shaped Metal Liner, Figure 2.

Figure 1

NOTE: T-shaped liner shipped with unit as standard. Rectangular shaped metal liner available for on-site Wood Hood construction, Fig- ure 4.

4. The ventilation system (power module and ducting system) is not included and must be purchased separately.

B. Installation: Metal Liner – T-Shaped, Figure 3

1. Measure up 6 1/8 from the bottom of adjacent cabinets. Scribe a level line horizontally across depth of both cabinets.

Figure 2

2.Raise Metal Liner so that bottom edge of liner is level with scribed lines. Use four (4) #8 x 1/2”screws provided to attach

liner to adjacent cabinets through pre-drilled holes in liner. (If metal liner is not flush to cabinet sidewalls, it may be neces- sary to use a filler piece to avoid bowing the liner.) Locate studs and place two #8 x 1 1/4”, supplied, through rear of liner.

C. Installation of Omega Industries, Inc.’s decorative

Wood Hood:

1. Slide decorative hood front into position over T-Shaped liner and between adjacent cabinets. Install the hood front by ad- joining to adjacent cabinets through the front frames using (4) #8 x 2 1/2”screws (not provided).

Figure 3

Form OME-03 12/2002 ©2002 Omega Industries, Inc.