Safety instructions | Operation |
your finger on the switch when carrying the machine or if you connect the running machine to the socket, this may lead to accidents.
(d)Remove the adjusting tools or the spanners before switching on the machine. A tool or a key which is located in a revolving part of the machine may lead to injuries.
(e)Concentrate at all times. Ensure a safe stand and keep your balance at all times. In this case you will be able to control the machine better in unexpected situations.
(f)Wear suitable clothing. Do not wear any loose clothing or jewellery. Keep your hair, clothing and gloves clear of any moving parts.
(g)If dust extraction or collection devices can be mounted, make sure that they are connected properly and are used in the proper way. The use of these pieces of equipment reduce hazards caused by dust.
4)Careful handling and use of electric tools
(a)Use the correct tool for the job at hand.
(b)Do not use an electric tool, if the switch is defective. An electric tool, which cannot be switched on or off, is dangerous and has to be repaired.
(c)Remove the plug from the socket before setting down the machine, changing accessories or putting the machine aside. This precautionary measure prevents the unintentional start of the machine.
(d)Keep unused electric tools out of reach of children. Do not permit persons to use the machine who are not familiar with it or who have not read these instructions. Electric tools are dangerous, if they are used by inexperienced persons.
(e)Maintain the machine with care. Please check whether the movable parts are perfectly operational and do not jam, whether parts have broken or have been damaged in such a way that the function of the machine is impaired. Have damaged parts repaired prior to using the machine. Many accidents are caused by electric tools which are poorly maintained.
(f)Keep all cutting tools sharp and clean.
(g)Use the electric tool, the accessories, the insert tools, etc according to these instructions, and in the way described for this special type of apparatus. In the process, take the working conditions and the work to be carried out into consideration. Only use this belt sander for the purpose for which it is intended.
(h)Use clamps or vice to hold work. It is safer then using your hands and frees both hands to operate the tool.
The ON/OFF switch
•To switch on the tool, press and hold the on/off switch (1, Fig. A1, page 4).
•If you release the on/off switch (1, Fig. A1, page 4), the tool will be switched off.
•You can lock the on/off switch by pressing the on/off switch (1, Fig. A1, page 4) and then button (5, Fig. A1, page 4). The switch lock can be released by briefly pressing the on/off switch (1, Fig. A1, page 4).
•Do not put the machine down when the motor is still running. Do not place the machine on a dusty surface. Dust particles may enter the mechanism.
Usage tips
•Hold the machine in rest position on the workpiece when switching the ma- chine on or off. Otherwise the cutter in the collet may damage the workpiece. The cutter in the collet may damage the workpiece.
•Clamp the workpiece and make sure that the workpiece cannot slide from un- der the machine during the cutting activities.
•Hold the machine firmly and move it evenly over the workpiece. Do not force the machine.
•Only use cutters which do not show any signs of wear. Worn cutters have a ne- gative effect on the efficiency of the machine.
•Always switch off the machine first before removing the plug from the wall socket.
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005 |
| Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005 |
|
Web Support: www.omegawolf.com/powercraft |
| Web Support: www.omegawolf.com/powercraft |
|
Model Number: | 08 | Model Number: | 13 |
|
|
|
|
