INTRODUCTION
Your OMEGA DPCl
Plastic | FRONT VIEW | |
| ||
front panel- |
| |
sealed to | ||
meet | display | |
| ||
Programming | I Reset/ | |
Programming | ||
button | ||
button | ||
| ||
| REAR VIEW |
APPLICATION
You must make certain programming and wiring choices to accomplish your application. We recommend the following sequence:
1.Answer the following questions:
??W hat type ofsensor will be used?
??What engineering units should the counter be scaled to?
??How many pulses per item is the sensor providing?
??Is a decimal point needed on the display?
2.Calculate the scale factor.
MOUNTING
1 ‘~‘lnstall mounting clip
PROGRAM MODE
NOTE: To enter the program mode, you must connect a jumper between terminals 1 and 5 (see page 4). To leave the program mode, disconnect the jumper.
Screens
There are four
display screen 1. Press and hold the 141 key while repeatedly pressing them key to advance to successive screens.
,
OPERATION
Add/Subtract Counting
There are two count input terminals on the rear of the totalizer. Count pulses entering Input A (terminal 3) cause the total to decrement (count down). Count pulses entering Input B (terminal 2) cause the total to increment (count up). The totalizer may start counting from zero, when reset, or may start from a
If only one of the count inputs is used, the totalizer becomes an up counter with a range of zero to 99,999,999, or a down counter with a range of zero to
Count Inputs
The
The
Page 2