Never submerge or wet the AC power unit or cord. Doing so could result in electrical shock.
Never operate the unit with the water tank empty. Use only water in the tank. Solutions other than water may cause da- mage to the transducer.
Change the water in the water tank after each use.
Warning: Never remove the cover during operation – severe injury could occur.
Preparation
NE | |
|
English
➀Filling cooling water
Before filling cooling water or medication, be sure the power is OFF ( 
). (Nebuliser lamp is OFF and the power cord is unplugged).
Remove the cover by slightly pushing the rear part of the cover to move it upwards.
Lift the medication cup holder by slightly pushing the front panel of the tank holder and lifting it up.
➁Filling Medication
Place the nebuliser on a table or another flat and stable surface.
Information |
on inhalation |
8 |
Correct |
|
|
water level | NE |
When inhaling you should sit upright and relaxed. You should sit at a table and not in an armchair as otherwise you will con- strict your respiratory passages and impair the effect of inhala- tion. If you must be treated in bed, support yourself with pillows so that you will sit as upright as possible.
One treatment should not last longer than 15 minutes. Consult your doctor concerning the appropriate inhalation time.
Always be calm and relaxed when you inhale. Allow time for the inhalation to take effect after you have finished using the nebuliser.
Breathe in slowly and deeply so that the medication can reach deep into the fine bronchial tubes. Hold your breath for a short time, then breathe out slowly. Do not try to breathe too quickly. Take a pause when you feel like having it.
Before using the nebuliser for the first time it must be cleaned according to the cleaning instructions.
Fill the water tank ( with tap water or distilled water) to the correct level. (In between the two lines).
Caution:
1.Never fill the water tank with solutions other than water. Damage to the transducer could occur.
2.Be sure to fill the water tank to the proper level. The unit will not operate if the water level is low.
Place medication directly into the medication cup.
•Never use more than 10 ml of solution.
•Be sure all parts are clean before operating.
The medication cup has a 10 ml capacity. Never overfill.
9
