Omron NE U07 instruction manual Start the treatment, End, Operation, Cleaning, ➂ Assembling

English

NE -U07

NE -U07

Start the treatment

➂Assembling

Mount the medication cup holder and the cover onto the main unit.

Couple the main unit with the AC adaptor. (Fit them by pressing until it clicks).

Connect the plug to a wall-plug (AC 220V – 230V~).

Caution:

Before plugging the unit in, make sure that the voltage rating on the back of the AC Adaptor and the supply voltage value match.

Press the -button for intermittent operation. The nebuliser will not operate if it is not pressed.

Press the OFF/ON ( )-button for continuous operation. The nebuliser will operate continuously until it is pressed again, which stops the unit.

Notes:

1.During operation a green power light will illuminate. This light must be lit for the unit to operate.

2.The unit is equipped with a heat sensor. If, during operation, excessive heat occurs, the unit will automatically shutoff. The unit will operate properly when normal operating tem- perature is reached. Store the unit in a well ventilated loca- tion (near an open window for example). Please wait at least 30 minutes before restarting inhalation.

End of

operation

Cleaning

Aerosol output is adjustable by rotating the delivery rate adjust knob placed on the cover.

Rotate the knob counterclockwise to increase the rate, or clockwise to reduce the rate. Adjust it to your requirements.

Sit relaxed at a table and breathe in the aerosol delivered through the mouthpiece or air tube (optional part).

Press the continuous operation button ( ) after use. (Nebuliser lamp goes out).

➀Remove the plug from the mains socket.

(Do not pull the power cord. Be sure to pull it out by

holding the power plug).

➁, ➂ Lift the casing up, while pressing the front and rear unlock buttons of the AC adaptor. Remove the main unit.

➃, ➄ Remove the cover and the medication cup holder from the main unit.

10

11