How to Measure Blood Pressure
2.Measurement is over and blood pressure values and pulse are displayed.
When the measurement is over, a 
mark flashes, and the cuff
deflates automatically. Then a 
mark turns on and blood pressure and pulse rate are displayed simultaneously.
Display of measurement results
| Systolic Blood Pressure |
Pulse | Diastolic Blood Pressure |
|
*If a measurement cannot be made or the blood pressure values are displayed abnormally high (low), refer to Page 15.
*If the Velcro tape comes off during the measurement, wrap the wrist cuff snugly as shown in Page 7 and measure again after fastening the Velcro tape.
3. Turn off the power.
Blood pressure measurement is complete now. Press the START/STOP button to turn off the power.
To make another measurement, repeat the procedure in Step 1 above.
* Even if you forget to turn off the power, the monitor will turn off automatically in approximately 2 minutes.
10
