Listening to the Radio
This section describes the procedure using the but- tons on the front panel unless otherwise specified.
Using the Tuner
With the
This model changes FM/AM frequency in 200/10kHz (or 50/9kHz) steps (➔ 31).
■Manual tuning mode
1Press TUNING MODE so that the AUTO indicator goes off on the display.
2Press and hold TUNING q/w.
The frequency stops changing when you release the button.
Press the buttons repeatedly to change the frequency one step at a time.
In manual tuning mode, FM stations will be in mono.
Listening to the Radio
Press TUNER to select either “AM” or “FM”.
In this example, FM has been selected. Each time you press TUNER, the radio band changes between AM and FM.
Band Frequency
Tuning into Radio Stations
■Auto tuning mode
1Press TUNING MODE so that the AUTO indicator lights on the display.
2Press TUNING q/w.
Searching stops when a station is found.
When tuned into a station, the TUNED indicator lights. When tuned into a stereo FM station, the FM STEREO indicator lights on the display, as shown.
FM STEREO
AUTO
TUNED
Tip
•Alternatively, you can use the remote controller’s TUN MODE and arrow buttons.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to manual tuning mode and listen to the station in mono.
Tip
•Alternatively, you can use the remote controller’s TUN MODE and arrow buttons.
■Tuning into stations by frequency
You can tune into AM and FM stations directly by enter- ing the appropriate frequency.
|
|
|
1 | On the remote controller, press TUNER repeat- | |
| edly to select “AM” or “FM”, followed by D.TUN. | |
|
|
|
|
|
|
|
|
|
2 | Within 8 seconds, use the number buttons to enter | |
| the frequency of the radio station. | |
For example, to tune to 87.5 (FM), press 8, 7, 5.
If you have entered the wrong number, you can retry after 8 seconds.
En
21
