Supplied accessories
Check that the following accessories are supplied with this unit.
The following accessory is available on the models other than U.S. and Canadian models.
AM loop antenna ⋅ 1 | FM indoor antenna ⋅ 1 | 75/300 ohms antenna adapter ⋅ 1 | |
REMO | TE CO |
|
|
|
|
| |
| NTRO |
|
|
| LLER |
|
|
RC- 421S
Remote controller
Before operating this unit
1
2
3
Remote control sensor
30° 
30°
approx. 5 m
(16 feet)
Installing the remote controller batteries
1.Remove the battery compartment cover by pressing and sliding it out.
2.Insert two AA (R6- or
3.After batteries are installed and seated correctly, replace the com- partment cover.
Notes
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.
•Remove dead batteries immediately to avoid damage from cor- rosion. If the remote controller doesn’t operate smoothly, replace both the batteries at the same time.
Using the remote controller
Point the remote controller toward the remote control sensor.
Notes
•Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.
•Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Plac- ing the unit behind such doors may prevent proper remote con- troller operation.
•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.
5