Before using this unit
Connection
•The speaker cabinet is made of wood and is therefore sensitive to extreme temperatures and humidity. Avoid placing the speaker systems in locations subjected to direct sunlight, or in smoky or in humid places, such as near an air conditioner, humidifier, bathroom, or kitchen. Doing so may result in damage to the speaker.
•Place the unit on a rigid, level surface. Placing it on a slanted surface or weak base not only may cause the unit to fall, but also results in decreased sound quality.
•Keep water or other liquids away from the unit. If water is spilled into the unit, not only the unit but also the speakers themselves may be damaged.
Name and function of each part
| Grille plug hole | Cabinet |
|
| |
Tweeter |
| 198 mm |
|
|
220 mm
130 mm | 216 mm |
WooferGrille
Attaching and detaching the speaker grilles
This speaker system uses detachable grilles. Use the follow- ing method to attach or detach the grilles.
1.While holding the bottom edge of the speaker grille with your both hands, pull it gently toward you to remove the bottom of the grille.
2.In the same way, gently pull the upper edge of the speaker grille toward you to remove it from the main unit.
3.To attach the grill, push the projections at the four corners into the grille plug holes on the speaker cabinet.
Removal | Replacement |
2
•Turn the sound volume to the minimum and disconnect the power cord to the amplifier before connecting the speaker cables.
•The nominal impedance of this speaker system is 5 Ω. Use only amplifiers capable of handling this impedance.
•Use the speaker cables to connect between speaker’s terminals and the amplifier’s speaker terminals as illus- trated below.
•Connect the terminals of the Right and Left speakers (when viewed from the front side) with the amplifier’s right
(R) and left (L) speaker terminals, respectively.
•Connect the speaker cables securely to the terminals, with the core wires twisted properly.
•Press the lever, securely insert the cable’s core wires, and then release the lever.
Pull lightly on the speaker cables to ensure that they are connected securely.
Right speaker | Left speaker | ||||
|
|
|
|
|
|
Positive (+) side is indicated with a description or a white line.
Before turning on the amplifier’s power switch:
•Make sure that the positive (+) and negative
•Be sure to connect the speaker cables with correct polarity (connect the speaker’s positive (+) and negative
•Pull lightly on the speaker cables to ensure that they are connected firmly.
