Onkyo HT-R410 instruction manual Enjoying CD, If no sound is heard

CD player

DIGITAL

OUT

OPTICAL

L

AUDIO OUT

(PLAY)

R

Enjoying CD

1.Connect the CD player.

	FM
AM
	75 ANTENNA

VIDEO 3 VIDEO 2		VIDEO 1		DVD	MONITOR
	IN	OUT	IN	IN	OUT
DIGITAL INPUT					S VIDEO
OPTICAL COAXIAL REMOTE
CONTROL
IN	IN	OUT	IN	IN
					VIDEO

IN	OUT	IN	IN	IN	OUT	IN	FRONT	SURR	CENTER
L								L
SUBWOOFER
PRE OUT

R R

	TAPE			SUB
CD		VIDEO 3 VIDEO 2	VIDEO 1	WOOFER

DVD

3

9

7-1

4

	7-2
10	5
	8

2.Connect the power cord to a wall outlet.

3.Turn on the power.

The STANDBY indicator turns off, and the display area lights up. Make sure that the power switch on the CD player is also turned ON.

4.Select the speaker system(s) to be used.

5.Set the Input Select to CD.

6.If you connect the digital output jack of the CD player to the OPTICAL jack on the HT-R410 in step 1, proceed to step 7. If you connect to the COAXIAL jack on the HT-R410, perform the following settings.

1Press the DIGITAL INPUT button on the HT-R410. The default CD setting (Optical) appears.

2Press the DIGITAL INPUT button repeatedly to select “Coaxial”.

7.Play a CD.

When an Onkyo CD player is z-connected, you can control an Onkyo CD player using the remote controller of this unit.

You need to enter the manufacturer’s code “300”. (See pages 33–34 of the main manual for details.)

How to play a CD using the remote controller:

1Press the CD/DVD button.

2Press the sbutton.

8.Adjust the volume.

9.Select the listening mode.

The selectable listening mode varies depending on the source. (See pages 28–29 of the main manual for details).

10.Select the audio mode.

You can compare the analog and digital sound. (See page 26 of the main manual for details).

If no sound is heard.

The power turns on but no sound is heard.
The MUTING indicator flashes.	Press the MUTING button on the remote controller to turn off the
	MUTING indicator
The headphones are connected.	Disconnect the headphones.
The connections are incorrect.	Make sure that all connections are made correctly.
The digital input setting is incorrect.	Make sure that correct input source is set in step 6 above.
The power does not turn on.
The connections are incorrect.	Make sure the power cord is connected correctly.
The external noise has affected the internal .	Unplug the power cord from the AC outlet to turn off the unit and then
	plug it again after about five seconds.