Onkyo HT-S3300 instruction manual Controlling Other Components, Preprogrammed Remote Control Codes

Controlling Other Components

You can use the AV receiver’s remote controller (RC-762M) to control your other AV components. This section explains how to enter the remote control code for a component that you want to control: DVD, TV, CD, etc.

Preprogrammed Remote Control Codes

The following REMOTE MODE are preprogrammed with remote control codes for controlling the components listed. You do not need to enter a remote control code to control these components.

For details on controlling these components, see the pages indicated.

BD/DVD Onkyo Blu-ray Disc player (➔ 45) TV/CD Onkyo CD player (➔ 45)

PORT Onkyo Universal Port Option Dock (➔ 42)

Entering Remote Control Codes

You’ll need to enter a code for each component that you want to control.

1 Look up the appropriate remote control code in the Remote Control Codes for Onkyo Compo- nents Connected via u.

2 While holding down REMOTE MODE to which you want to enter a code, press and hold down DISPLAY (about 3 seconds).

Note

•Remote control codes cannot be entered for RECEIVER.

•Apart from RECEIVER, remote control codes from any category can be entered for REMOTE MODE. However, these buttons also work as input selector buttons (➔ 21), so choose a REMOTE MODE that corresponds with the input to which you connect your component. For example, if you connect your CD player to the CD input, choose TV/CD when entering its remote control code.

3 Within 30 seconds, use the number buttons to enter the 5-digit remote control code.

The remote indicator flashes twice.

If the remote control code is not entered success- fully, the remote indicator will flash once slowly.

Remote Control Codes for Onkyo Components Connected via u

Onkyo components that are connected via uare con- trolled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.

1 Make sure the Onkyo component is connected with an ucable and an analog audio cable (RCA).

See “Connecting Onkyo uComponents” for details (➔ 18).

2 Enter the appropriate remote control code for

REMOTE MODE.

•BD/DVD

`31612:

Onkyo DVD player with u

•TV/CD

`71323:

Onkyo CD player with u

`42157:

Onkyo cassette tape deck with u

•PORT

`82351:

Onkyo Universal Port Option Dock

•TUNER

`51805:

Onkyo AV receiver’s tuner

See the previous section for how to enter remote control codes.

Note

•When using a cassette tape deck connected via u, press and hold TV/CD to switch to TAPE.

3 Press REMOTE MODE, point the remote control- ler at the AV receiver, and operate the component.

If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that’s not connected via u, use the following remote control codes:

•BD/DVD

`30627:

Onkyo DVD player without u

•TV/CD

`71817:

Onkyo CD player without u

`11807: Onkyo TV

En

44